If you are a distiller and need to fine tune the tension on your ProBoil or regular gasket sealed distilling lid, these clamps will do the trick. They fit all versions of the Brewzilla, Digiboil and Robobrew.
This set of 4 adjustable stainless steel clamp set fits the 35L and 65L BrewZilla Gen 3 all the way to Gen 4 as well as all 35L and 65L DigiBoils. It also suits the 12L and 24L Boiler Extensions.
Instructions:
1. You will need a pair of bolt cutters or tin snips to cut the current clamp off. (Please see product photos for optimum cut location).
2. Remove the nut and bolt and thread it through the clamp. Ensure that the grooved part is facing outwards (photo for reference). If you do not have the grooved part facing outwards, the clamp will found on the round lip of the boiler.
3. Loosen the bolts and spin the clamp up or down to adjust the tension. Use the nuts to lock the desired tension. It is always best to start looser than you think, then adjust tighter.
Note: Do not use these on glass lids or when brewing, these are only for fine tuning tension when using a distilling lid.
You can be the first one to write a review.
Nov 28, 2024 by Chris
Q: Will these fit a mash n boil?
A: No, these just fit the Brewzilla
