Cutter designed for Duotright EVAbarrier tubing and other tubing up to 1/2" exterior diameter. Features a hooked tool on the end to press open Duotight press fit connections. Makes clean straight cuts every time.
You can be the first to ask a questions.
Broke on first use
The cutter is fine, but the hooked tool for opening connections broke the first time I tried to use it.
mixed performance
Overall a good tool. Makes straight square cuts. With the softness of the eva barrier tubing materials, there is some flattening of the tubing before the cutter point pierces. Maybe reshaping the tip into two points would help to reduce the squashing.
Needed for duotight tubing
I think this is a must have if your going to use duotight tubing. I tried just using scissor but the buts were always off a bit. This helps to get a good staight cut and can be used on other tubing as well. It goes have a little wobble but for the money its worth it.
Just OK
Cutter has some play \ wobble so if you do not pay attention it will not be a straight cut. I mainly purchased for the duotight tube remover at the end. Unfortunately this broke on me pretty quick as you need to apply some pressure to remove the tube from a duotight fitting. You can remove just by using needle nose or something similar. Unfortunately I made my connection tubes on duotight spunding valve were a little short and I cannot use plyers to remove the tubing as there is not enough room. The end tool is what I need and it broke on me.