This gas distributor (with a machined aluminum billet body) features ¼" male flare threaded fittings, so they will fit standard ¼ female flare threaded fittings, like our D03 Ball Lock Gas Connector.
Great for distributing gas from a single regulator to 4 kegs. Check valves are included on outlet valves to prevent beer from backing up into your gas liines. On the aluminum billet body, the end opposite the inlet barb is plugged with a ¼ male NPT plug. This can be removed and another brass valve or part like our Q87, D16, or D69 (at left) installed. 10" long.
Mar 19, 2024 by Mike
Q: Can the plug at the end of the unit be replaced with a ball lock post (product X44)
A: Yes, although the plug at the end is sealed with a locktite type sealant, and can be very hard to remove.
Feb 09, 2024 by Nagorg
Q: Can the inlet be switched from the left side to the right side?
A: Yes, use a 14mm deep wall socket or closed end wrench for best results
Fittings Too Tight
I couldn't remove the fittings on the sides because they were on too tight. I sent it back for another one.