Jul 24, 2023 by Joe

Q: What is the warranty of the mill?

A: 1 Year

Oct 10, 2021 by Perry Savino

Q: Does anyone know what the amp draw is on this grinder?

A: The optional 24 volt transformer, item X84, draws 2.27 amps at 110 volts.

Aug 11, 2021 by Paul Grimes

Q: Is the mill suitable for use with conditioned grain, which has been dampened with water (1-2% by weight)?

A: We have never tested it with dampened grain, because it works so well with dry malt we have never seen a need to do this. KegLand has tested it, and found conditioned grain ran through the mill very well.

Aug 11, 2021 by John

Q: What is the approximate RPM of the rollers with the optional power supply?

A: We have not checked the roller RPM. However Kegland says using a 24 volt output power supply will achieve the best results. The speed would be the same whether it is a 24 volt battery or 24 volt DC converter. When connected to a 24 volt DC power supply it crushed 2 pounds of grain in 1 minute 10 seconds.

May 21, 2021 by Mat

Q: I’d really like to know the best gap sizing for this device. The dials on the side have mm markings but they don’t relate to actual gap sizing. So far, .25 and .50 (left and right) were way to tight and .75 and 1.00 (left and right) was allowing grain to pass through uncrushed. I’m going to try .75 and .75 next.

A: Without reading the tiny marking molded into the adjusters, we find straight down with the notched adjusting knobs is good and is where we start when crushing grain. Depending on the type of malt you have, of course, this may vary.

Ask a Question