Very cheap and flimsy

Review by Nathan on 1/24/2020

If your hole is not perfectly square through the cooler insulation it will leak because the seal is super thin. The gauges themselves are not very sturdy. The way they are calibrated is by turning the outside cover relative to the body. If it gets bumped at all the temperature will need to be calibrated during the brew process which is not easy to do while you are brewing. I end up buying some much more robust thermometers on xxx. I would recommend these.

NOT Accurate. Cheaply made!

Review by Chad O on 5/25/2018

As others have mentioned, it's easy to knock the thermometer out of calibration. The point of buying 2 of these....one for sparge tank and one for mash tun, was to cut down on brew time and limit variables. Now, I have to make sure each thermometer is calibrated before I begin a brew and I remain paranoid during mashing/sparging. Waste of time and money.

Nice Fit

Review by G. Smith on 5/5/2017

Product sealed really well on 10 gallon igloo mash tun. Dial was accurate and true, but be sure to place it close to the bottom. For some 5 gallon all grain batches it needs to be fairly low on the cooler to get a good reading...and once you drill the hole, your done.

Worked well for a while, but now it's dead.

Review by Teo on 12/31/2016

This product was easy to install and fit perfectly in my mash tun. It only lasted less than a year... now I am looking for another one. :(

Easy to install, works as advertised

Review by Tony Oberkirch on 8/3/2016

Easy to install, had a small initial leak that was quickly and easily corrected. Seems to be very accurate. Nice, inexpensive addition to my rig that should improve my beer.